Stories
How to measure the girth of your arm for properly fitting leather sleevesA leather sleeve should stay in place without restricting movement. If it is too tight, it can limit grip, cause discomfort and interfere with tasks requiring…
How shoulder yoke construction improves FR shirt range of motionOn a working site, a shirt has to move before it needs to look neat. A welder raises a rod, an electrician lifts a ceiling panel, and a tradesperson reaches…
Choosing Welding Gloves for a Secure Grip on Wet MetalWet metal creates a difficult combination for welders: smooth surfaces, reduced friction, water contamination and heavier tools. A glove that feels reliable on…
The Best Way to Remove Spatter Burns from Your Welding Apron’s SurfaceWelding spatter can leave small beads of fused metal, blackened patches, and brittle scorch marks across a leather or flame-resistant apron. Removing the loose…
How To Spot UV Damage On Leather Welding SleevesLeather sleeves are a practical barrier against sparks, radiant heat, sharp edges and brief contact with hot materials. They are common in Australian…
A Better Fit Starts at the NecklineA welding apron has a demanding job. It must shield the chest, waist and upper legs from sparks, hot metal and grinding debris while allowing the wearer to…
Choosing a Cotton and Synthetic FR Shirt for Australian WorkA flame-resistant shirt has to do more than resist ignition. It should suit the hazards of the job, remain comfortable through long shifts and hold its…
What Back Padding Adds To Welding Glove Impact ProtectionWelding gloves are built to manage several hazards at once: radiant heat, sparks, sharp edges, molten-metal splatter and contact with hot tools. Padding sewn…
How to Test the Flexibility of Your Leather Sleeves After Long StorageLeather sleeves can look well preserved after months in storage while becoming stiff, dry or less pliable around the cuffs and seams. A gentle flexibility…
Why a Welding Apron with a Tool Loop Can Keep Your Chipping Hammer HandyWhen you're up to your elbows in slag, the last thing you want is to be hunting around for your chipping hammer. Most tradies have been there — you tap a weld…